Jump to: navigation, search

XWAU Guidelines

These are the guidelines for designing the actual flight models. In case you consider joining the group please consider those!

starfighters/corellian transports

All flyable craft should be created with base, exterior and cockpit model. - The Base model is the model used by AI-controlled NPC ships. - The Exterior model is used by player craft in 3rd person view. It is higher in detail than the Base model - THe Cockpit model is used when in 1st person cockpit mode. It is highly detailed and contains all the exterior parts visible by the player when in this mode.

BASE MODEL

Note: Also applies to utility craft, shuttles, small transports or other fighter or transport-sized craft not flyable by the player) Illuminated textures on tips of engine nacelles for "glow"

EXTERIOR

Use "ejected" pilot rescaled to 1.7 meters in height for Rebel and Neutral fighters. Imperial craft use Matt's new Imperial pilot Transparent canopy Use same cockpit interior used for the COCKPIT OPT Engine intakes are hollow (double layered with the back wall slightly smaller in diameter to give "width") with 3D turbines (if known or visible) and support beams Engine exhaust nacelles are also hollow with illuminated textures on back wall for engine "glow" See A-wing and X-wing screenshots for examples

COCKPIT

No maximum face limit

The COCKPIT model is centered on cockpit location on the EXTERIOR OPT, with in-game POV to be set accordingly. Craft with off-center cockpits or pilot's seats (such as the side-by-side seats on the CORTs and Planetary Fighter) to be properly offset Use illuminated textures for computer displays Canopy frame not to be distorted to promote visibility Rebel and most Neutral starfighters have 3D flight sticks and throttle controls Imperial starfighters use Matt's flight yoke Larger Neutral starfighters (such as the Planetary Fighter and Pursuer) use flight yoke All parts of the hull visible from the cockpit to be show

Engine glow

Starfighter Engine Glows use TWO glows for the effect: a smaller, brightly colored glow for the actual glow, and a second outer corona. The outer glow is larger in diameter, but the inner glow is longer. Coloration and exact diameter of the two is to be determined by the size of the engines. See screens of already completed glows for examples.

starships

No maximum face limit (within reason) No laser turrets unless visible in the actual film models. If no turrets are visible, use hull mesh hardpoints Engine nacelles are hollow inside Illuminated textures for windows, back wall of engines

Platforms, satellite, mine, probe

requirements to be determined